2003
Subaru Impreza
8000K 9007 McCulloch HID Install
- Tools:
- 1
HIDPlace.com HID Kit
- 10MM Socket
Wrench
- Flat Head
Screw Driver
- 1) It is
recommended to unplug your
battery, but not always needed.
- 2)
Remove your grille, but pulling
off the tabs 4 of them keep the
stock grille in place and 2 tabs
keep the body colored pieces in
place which go between the
grille and head lamp (2 on each)
- 3a)
Remove your airbox/intake, with
10MM screws, (WRX Models 2
screws, RS Models 1 Screw)
connected to the area where the
grille was.
- 3b) If
you would like to remove your
head light plase see step 9 For
instructions
- 4)
Remove stock bulbs, but twisting
dust caps and then pulling out,
then remove the old bulbs from
their harness.
- 5a)
Connect the stock harness with
the harness connector which
comes in the kit.
- 5b) Make
sure to connect the black and
white wires in to the harness
which comes with the kit
- 6)
Connect and secure all wiring
using the zip ties and double
sided tape provided. Please
select a secure area where the
wires and ballast do not come in
contact with any moving or high
heat parts.
- 7) Place
HID Bulb in to Headlight and
then secure with dust cap. Then
connect the 2 wires from the
bulb to the 2 wires which come
from the ballast
- 8) Check
Bulb if it works, make sure to
start the car first before you
turn on the lights.
- 9)
Remove drivers side head light,
3 10 MM screws, 1 located on the
fender on top of the head light
and 2 located on the passanger
side of the head light connect
to the black plastic holder.
- 10)
Repeat steps 4-8
- 11)
Allow head lights to sit in the
on poistion for 10 minutes with
the engine running.
- Trouble
Shooting:
- - Lights do
not turn on: try upgrading to 20A
Fuses
- - Lights
Strobe: check wiring and make sure
Day time running lights are
disconnected.
- - One light
does not work: try it on the other
side and double check wiring.
- Before:
- Between:
- After:
|
|
|
|
